AT3k faceplate
2 posters
Page 1 of 1
AT3k faceplate
You know how when you single an AT3k you get that huge hole in the front of the shell? Like this:
Well, I made a template for a plastic piece to cover that hole. The hole in the center should fit a 1/2" PVC coupler.
The total size of the image is 3x3 inches or 216x216 pixels at 72ppi, make sure that it is being printed out at that size.
Then, cut it out:
And glue it on:
Then you're all set for sanding/painting. Of course, where I am its freezing outside, so it may be a while before I get to that. I know this isn't much, but I think that it looks much more finished than before. I would make a 2k one also, but I don't have access to a singled one.
Well, I made a template for a plastic piece to cover that hole. The hole in the center should fit a 1/2" PVC coupler.
The total size of the image is 3x3 inches or 216x216 pixels at 72ppi, make sure that it is being printed out at that size.
Then, cut it out:
And glue it on:
Then you're all set for sanding/painting. Of course, where I am its freezing outside, so it may be a while before I get to that. I know this isn't much, but I think that it looks much more finished than before. I would make a 2k one also, but I don't have access to a singled one.
analogkid- Number of posts : 12
Age : 31
Registration date : 2009-01-07
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|